Battery-Front Panel-Keypad AssemblyBattery Pack Removal1. Open and remove the battery door (13) at the bottom of the instrument. Note:When installing a replacement Battery Pack, be sure to charge the Battery Pack for 24 hours. Refer to Battery Maintenance on page 4—1. 2. Remove the Battery Pack (A13). 3. Free the Battery Pack by pressing the locking tab on the battery harness and separating the two connectors. Front Panel Bezel and Keypad Assembly Removal1. Press in on the right edge of the front panel bezel (2) as illustrated in Figure 4—1 (arrow A). 2. While pressing the edge, push out in the direction of arrow B until the right edge of the bezel releases. 3. Slide the bezel to the right slightly (arrow C) until the left tab clears the front case (5). 4. Place fingers under the released edge and pull the bezel away from the case (arrow D). 5. Press the quick—release levers and disconnect J20 from the Keypad Assembly (A6). 6. Remove the two screws (40) that hold the Keypad Assembly and CRT implosion shield (45) to the bezel. Slide out the shield and the Keypad Assembly.
|
